Thursday, March 23, 2023
Login

2008 PDF Archives

Parent Category: PDF Archives

 

 

JANUARY 2008
Vol. 7 No. 1

Predicting Probable Cavity Resonance with a 3D EM ToolYeap Yean Wei, Frank Demming-Janssen, and Linus Lau Ngie Ung

Productivity by Design: ADS 2008 Reduces Steps to Simulation and Verification—How-Siang Yap

Power Combiners, Impedance Transformers and Directional Couplers: Part II—Andrei Grebennikov

Tutorial: Top-Down Design: An Introduction for New Engineers—Gary Breed

Editorial: Engineering Tasks Keep Moving to the Suppliers—Gary Breed

Technology Report: Development is Ramping up for ZigBee, IEEE 802.15.4 and Related Systems

Design Notes: Impedance Matching with LC Networks

   

FEBRUARY 2008
Vol. 7 No. 2

A Practical Approach to a Compact, Wide-Band SMT Directional CouplerRobert Torsiello and Kham Sanvoravong

Frequently Asked Questions About Noise—Ed Garcia

Power Combiners, Impedance Transformers and Directional Couplers: Part III—Andrei Grebennikov

Tutorial: Key Design Factors for Power and Ground Connections—Gary Breed

Editorial: An Update on Our Efforts to Give You Better Information—Gary Breed

Technology Report: Terahertz (THz) Technology: An Introduction and Research Update

Design Notes: Multiple Antenna Technology

             
 

MARCH 2008
Vol. 7 No. 3

Power Combiners, Impedance Transformers and Directional Couplers: Part IV—Andrei Grebennikov

Applying System-in-Package Technology to 16-Bit Digital Receiver DesignTodd Nelson

Design and Development of Microwave Filters on Metallized ABS Plastic—Jagdish Shivhare

Tutorial: Improving the Bandwidth of Simple Matching Networks—Gary Breed

Editorial: Wireless Applications for These Difficult Economic Times—Gary Breed

Technology Report: Recent Updates in Connector and Cable Technology

Design Notes: Matching Using Only 50-Ohm and 75-Ohm Transmission Lines

   

APRIL 2008
Vol. 7 No. 4

A 300 W Power Amplifier for the 88 to 108 MHz FM Broadcast Band—Antonio Eguizabal

Characterization of RF Transmission Lines on Ion-Implanted CMOS WafersKamaljeet Singh, Deepak Banghar and Surendra Pal

Low Cost Meets High Value in a Synthesized Signal Generator—Richard Houlihan

Spatial Combining of Multiple Microwave Noise Radiators—Jiri Polivka

Tutorial: A Review of the Performance Capabilities of Antenna Arrays—Gary Breed

Editorial: The 4G Battleground: Providing Content or Internet Access—Gary Breed

Technology Report: Models are Key in Design and Manufacturing Partnerships

Design Notes: Return Loss, Reflection Coefficient and VSWR

 

             
 

MAY 2008
Vol. 7 No. 5

Non-Linear Simulation of RFIC Amplifier Reference Design Boards—Hetvi Patel, Thomas Weller, Rick Connick and Lawrence Dunleavy

A High Dynamic Range Receiver for the Radar Open System ArchitectureFrank Cannata

Spectral Distortion in High Data Rate Remote Sensing Satellite Links—V. Sambasiva Rao and Surendra Pal

Building a Microwave Frequency Synthesizer—Part 1: Getting Started —Alexander Chenakin

Tutorial: Professional Development Activities to Enhance Your Career—Gary Breed

Editorial: Technical Discourse—One Idea Always Leads to Another—Gary Breed

Technology Report: University Research News

Design Notes: A Few Notes for the Laboratory

   

JUNE 2008
Vol. 7 No. 6

Building a Microwave Frequency Synthesizer—Part 2: Component SelectionAlexander Chenakin

IP2 and IP3 Design Considerations for a Direct Conversion I/Q Receiver—Doug Stuetzle

A Constant Mismatch Analysis of Power RF Transistors Using EDA ToolsJohn Pritiskutch and Craig Rotay

Tutorial: A Review of Common Line-Section Directional Couplers—Gary Breed

Editorial: Miscellaneous Comments on Diverse Topics—Gary Breed

Technology Report: Wireless Receiver Design Emphasizes Direct Conversion

Design Notes: Explore Software Defined Radio on a Budget

             
 

JULY 2008
Vol. 7 No. 7

Building a Microwave Frequency Synthesizer—Part 3: From Sketch to ProductAlexander Chenakin

Software Enhances the Design and Analysis of Tunable Circuits—Dale D. Henkes

Determining the CW Power Rating of Coaxial ComponentsAndrew Wierback

Tutorial: Manufacturers' Efforts Simplify Power Measurement for Specific Standards—Gary Breed

Editorial: Some Comments in Praise of Industrial Applications—Gary Breed

Technology Report: Digital Broadcasting Update: Changes are On Track

Design Notes: Reader Feedback

   

AUGUST 2008
Vol. 7 No. 8

Building a Microwave Frequency Synthesizer—Part 4: Improving PerformanceAlexander Chenakin

RF MEMS: Maturing Technology is Getting Ready for Primetime—Kamaljeet Singh and K. Nagachenchiah

BAW Flip-Chip Switched Filter Bank Delivers Dramatic Form Factor ReductionSteve Mahon, Joshua Zepess and Mark Andrews

Best Practices for Making Accurate WiMAX™ Channel-Power MeasurementsDavid Huynh and Bob Nelson

Tutorial: High Speed Digital Design Benefits from Recent EDA Tool Developments—Gary Breed

Editorial: The Value of WiMAX and Other Broadband Wireless Formats—Gary Breed

Technology Report: WiMAX Rollout Continues Progress Toward 4G Wireless

Design Notes: A Few High Speed Design Notes

             
 

SEPTEMBER 2008 
Vol. 7 No. 9

High-Efficiency Power Amplifiers: Turning the Pages of Forgotten History —Andrei Grebennikov

Building a Microwave Frequency Synthesizer—Part 5: Advanced Techniques—Alexander Chenakin

Tutorial: EDA Tool Options for Advanced High Speed and Wireless Design—Gary Breed 

Editorial: The Challenge of Top Performance in Military & Aerospace—Gary Breed

Technology Report: Recent Activities in Standards and Regulations

Design Notes: Some Notes on Electromagnetic Compatibility (EMC)

   

OCTOBER 2008
Vol. 7 No. 10

Cut Part Count and Increase Dynamic Range in the Hybrid Coupled AttenuatorChin-Leong Lim

Beamforming Boosts the Range and Capacity of WiMAX Networks—Paul Sergeant and Tong Swan Pang

Tutorial: A Review of the Major Types of RF and Microwave Coaxial Connectors—Gary Breed

Editorial: Work on Technology While You Worry About the Economy—Gary Breed

Technology Report: Innovative Packaging Puts Multiple Technologies into a Single Device

Design Notes: FCC News

             
 

NOVEMBER 2008
Vol. 7 No. 11

A Wide Dynamic Range Playback System for Radar SignalsDavid Friedman & Paul Hiller

Evolution of Broadband Signal Measurement and Analysis—Dennis Handlon

A Satellite Telemetry Transmitting System with Pre-Modulation Filtering—D.V. Ramana, R. Jolie, V.S. Rao & S. Pal

Tutorial: An Introduction to Defected Ground Structures in Microstrip Circuits—Gary Breed

Editorial: Working from the Ground up. A Lesson from the Election—Gary Breed

Technology Report: Trends in Test & Measurement: New Test Requirements, New Technologies

Design Notes: Jitter and Phase Noise Relationships

   

DECEMBER 2008
Vol. 7 No. 12

A High Efficiency Doherty Amplifier with Digital Predistortion for WiMAXSimon Wood, Ray Pengelly & Jim Crescenzi

Simulating and Designing a PLL Frequency Synthesizer for GSM Communications—Samir Kameche, Mohammed Feham & Mohamed Kameche

Tutorial: Design Notes for Laminates and Other Substrate Materials—Gary Breed

Editorial: U.S. Digital Television Transition Issues: Both Good and Bad—Gary Breed

Technology Report: A Review of Wireless Business and Technology

Design Notes: A Few Common Design Tradeoffs

March 2023

2023 03 HFE cover

The March 2023 Online Edition is now available for viewing and download!

View March HFE

 

Search

Web Exclusives

 2023 03 IronwoodClamshell

Clamshell Spring Pin Socket for Power Transistor

Constructed with stamped spring pin technology rated for 23GHz bandwidth with operating temperature range of -55C to +180C. Current capacity is 4 Amps with self-inductance of 0.93 nH and capacitance of 0.097 pF. With lever operation, it is easy to swap device and characterize.

Ironwood Electronics
Ironwoodelectronics.com