MARCH 2008
Vol. 7 No. 3

Power Combiners, Impedance Transformers and Directional Couplers: Part IV—Andrei Grebennikov

Applying System-in-Package Technology to 16-Bit Digital Receiver Design—Todd Nelson

Design and Development of Microwave Filters on Metallized ABS Plastic—Jagdish Shivhare

Tutorial: Improving the Bandwidth of Simple Matching Networks—Gary Breed

Editorial: Wireless Applications for These Difficult Economic Times—Gary Breed

Technology Report: Recent Updates in Connector and Cable Technology

Design Notes: Matching Using Only 50-Ohm and 75-Ohm Transmission Lines

APRIL 2008
Vol. 7 No. 4

A 300 W Power Amplifier for the 88 to 108 MHz FM Broadcast Band—Antonio Eguizabal

Characterization of RF Transmission Lines on Ion-Implanted CMOS Wafers—Kamaljeet Singh, Deepak Banghar and Surendra Pal

Low Cost Meets High Value in a Synthesized Signal Generator—Richard Houlihan

Spatial Combining of Multiple Microwave Noise Radiators—Jiri Polivka

Tutorial: A Review of the Performance Capabilities of Antenna Arrays—Gary Breed

Editorial: The 4G Battleground: Providing Content or Internet Access—Gary Breed

Technology Report: Models are Key in Design and Manufacturing Partnerships

Design Notes: Return Loss, Reflection Coefficient and VSWR

MAY 2008
Vol. 7 No. 5

Non-Linear Simulation of RFIC Amplifier Reference Design Boards—Hetvi Patel, Thomas Weller, Rick Connick and Lawrence Dunleavy

A High Dynamic Range Receiver for the Radar Open System Architecture—Frank Cannata

Spectral Distortion in High Data Rate Remote Sensing Satellite Links—V. Sambasiva Rao and Surendra Pal

Building a Microwave Frequency Synthesizer—Part 1: Getting Started —Alexander Chenakin

Tutorial: Professional Development Activities to Enhance Your Career—Gary Breed

Editorial: Technical Discourse—One Idea Always Leads to Another—Gary Breed

Technology Report: University Research News

Design Notes: A Few Notes for the Laboratory

JUNE 2008
Vol. 7 No. 6

Building a Microwave Frequency Synthesizer—Part 2: Component Selection—Alexander Chenakin

IP2 and IP3 Design Considerations for a Direct Conversion I/Q Receiver—Doug Stuetzle

A Constant Mismatch Analysis of Power RF Transistors Using EDA Tools—John Pritiskutch and Craig Rotay

Tutorial: A Review of Common Line-Section Directional Couplers—Gary Breed

Editorial: Miscellaneous Comments on Diverse Topics—Gary Breed

Technology Report: Wireless Receiver Design Emphasizes Direct Conversion

Design Notes: Explore Software Defined Radio on a Budget

JULY 2008
Vol. 7 No. 7

Building a Microwave Frequency Synthesizer—Part 3: From Sketch to Product—Alexander Chenakin

Software Enhances the Design and Analysis of Tunable Circuits—Dale D. Henkes

Determining the CW Power Rating of Coaxial Components—Andrew Wierback

Tutorial: Manufacturers' Efforts Simplify Power Measurement for Specific Standards—Gary Breed

Editorial: Some Comments in Praise of Industrial Applications—Gary Breed

Technology Report: Digital Broadcasting Update: Changes are On Track

Design Notes: Reader Feedback